|
PH-2B III
FAR INFRARED SAUNA WRAP
LOW-VOLTAGE FULL-ENCLOSURE
INFRARED ENERGY WRAP 3 Heating Zone: Targeted Calorie Burn &
Slimming
$535.00
Order Now
Compare Our Products With
Formostar Far Infrared system
for $9,000-$10,000
The Infrared Sauna Wrap PH-2BIII is a
low-voltage FIR device, with 3 separately controlled heating zones,
suitable for professional use at a spa, weight loss center or beauty
salon. Sturdy and made for frequent operation. Provides a complete
sauna experience. The Infrared Sauna Wrap is also portable and easy
to clean, for travel or home use. The Direct heat from the blanket
allows for gentle radiant relaxation of the muscles and controlled
perspiration.
INFRARED SAUNA WRAP PH-2BIII USER MANUAL |
INFRARED SAUNA WRAP PH-2BIII
COMPOSITION AND FUNCTIONS
PANEL DISPLAY AND FUNCTIONS OF THE KEYS
The Infrared Sauna Wrap PH-2BIII is
composed of a control box, a thermal blanket, a main power lead and
3 connection leads. The control box keeps a memory of the last
settings used
PH-2BIII PANEL DISPLAY AND FUNCTIONS OF THE KEYS:
ON/OFF |
Switch the system 'ON' or 'OFF'
|
Channel Key
|
Select the respective body zones (1-2-3). One or more zones can be targeted in a sauna session.
|
Temperature Key () |
Press to increase or press to decrease the temperature, 1 °C for each time pressed. |
Timer Key (
)
|
Press to increase or press to decrease the time, 5 minutes for each time pressed.
|
Overload Display
|
Overload indicator lights when the power surpasses 300W, and the alarm buzzer will sound. |
Start/Stop Key |
Press Start/Stop key to start or stop the device after setting the temperature and timer. |
INFRARED SAUNA WRAP PH-2BIII OPERATION PROCEDURE:
-
Place the Infrared SAUNA WRAP on a flat
surface, such as the bed or floor.
-
Wrap your body in the blanket. If a massage or body oil is used, then it is recommended to first wrap the body in a plastic film or sheet to protect the thermal blanket.
-
Put the control box on a flat surface such as a table and insert the plug into the main power socket.
-
Connect the leads labeled ‘1’ and ‘2’ between the control box and the thermal blanket. Connect lead ‘1’ to jack ‘1’ and lead ‘2’ to jack ‘2’, otherwise the heating system will not work.
-
Turn the main power switch on at the rear of the control box. The red ‘Power’ indicator on the control panel will light. The device has not started working yet.
-
Press the ‘ON/OFF’ key to start setting the temperature and the timer. The Channel key shows ‘1’ (body zone 1).
-
Press ‘Timer’
to set the working time. For each press, the time
will increase or decrease by 5 minutes.
-
Press ‘Temperature’
to set the working temperature. For each time pressed, the temperature will increase or decrease by 1° Centigrade. Set the temperature to your specific requirements.
Then press ‘Heating Zone’ key to change the zones. Repeat steps 6, 7, and 8 to set and start body zones 2 and 3.
Zone 1: Upper body and limbs (suggested temperature 38° C)
Zone 2: Mid body (suggested temperature 44° C)
Zone 3: Lower body and limbs (suggested temperature 42° C)
Press ‘Start/Stop’ key. The green indicator will light, showing that heating has started.
When the heating timer counts down to ‘0’, a signal will sound three times and the digital timer will display ‘0’ showing the heating has finished.
After using, pull the plug out from the power source.
If at any time you need to stop the session, just press the ‘Start/Stop’ key. When the green indicator goes off, the system has stopped working.
Fold the blanket and store it in a dry and cool place.
Other Suggested Use:
-
When the room temperature is lower than 20 °C, you may preheat the blanket for 10 minutes prior to use.
-
It is suggested that you are well hydrated by drinking a glass of water prior to using.
INFRARED SAUNA WRAP
PH-2BIII TECHNICAL SPECIFICATIONS |
Input Volts |
100V ~120V 60Hz / 220V ~240V 50Hz
|
Output Volts |
DC36V |
Input Power |
300W |
Materials |
Made of Nylon, covered by a layer of PU
(polyurethane) fabric, with heating elements of Space Carbon
Fiber |
Control Panel |
Manual Control
|
Heating Zones |
3 |
Temperature |
30°C ~ 60 °C |
Separate Heating Zone Controls |
YES |
Timer |
0~95 minutes |
Folded Size
|
187 x 70 cm / 72" x36 1/4"
|
Unfolded Size
|
180 x 195 cm
|
Net Weight |
8.3kg |
Warranty |
1 year |
|
Understanding Far Infrared Technology
Other
Far Infrared Products:
FIR Mattresses|FIR Sauna Domes|FIR Portable Saunas|FIR Body Wraps
These Infrared Heat Devices are not medical products.
Not intended to diagnose, treat, cure or prevent any disease. If you are uncertain whether you can use any of these products, please consult your physician before using it. The
information and statements made are for
education purposes and are not intended to
replace the advice of your family doctor.
|